Product Instruction Manual
10 Explanation of Symbols 220 - 240 Vac. A.C. Power Only 50 to 60 Hz Rated Mains Frequency Explanation of Symbols The date or a dating code
11 Operating Controls ACHIEVER (1)Power switch. Turns the power on/off. (2) Power indicator. Lights "green" whe
12 Operating Controls ACHIEVER Rear View (9) DC power terminal. The AC adapter provided supplies 24 V DC power. (10) Sens
13 Operating Controls ULTIMATE II (1) Power switch. Turns the power on/off. (2) Power indicator. Lights "green" w
14 Operating Controls ULTIMATE II (9) DC power terminal. The AC adapter provided supplies 24 V DC power. (10) Sensor input
15 Operating Controls ULTIMATE IISE (1) Power switch. Turns the power on/off. (2) Power indicator. Lights "green" when
16 Rear Panel Connections ULTIMATE IISE (1) DC power supply terminal [24 V IN, 1.2 A] Connect the specified AC adaptor (accesso
17 “F” Function ULTIMATE IISE Amplifier Function Output Connections Function Outputs are opto-isolated and are the equivalent
18 Operating Controls INNOVATOR (1) Power switch Turns the power on/off. (2) Power indicator Lights "green" w
19 Operating Controls INNOVATOR 9) DC power terminal The AC adapter provided supplies 24 V DC power. (10) Sensor input ter
2 Table of Contents Introduction………………………………………………. CE Declaration…………………………………………… Safety Instructions………………………………………. Explanation of Symbols…………………
20 Operating Controls RC-07 Infrared Receiver (1) Power switch Turns the power on/off. (2) Power indicator Lights "green" when
21 Operating Controls RC-07 Infrared Receiver (9) DC power terminal The AC adapter provided supplies 24 V DC power. (10) Sensor input term
22 (1A) Momentary power switch– Push to Talk. (1B) Continuous power switch– Slide up to lock on and then talk. (2) Power indicator –lights "green
23 (1) Power/Mute switch: Turns the power on/off. Press and hold to turn on/off. Press momentary to mute. (2) Power indicator—Lights green when the
24 1. Plug the charger into the wall (1) to the AC mains. 2. Connect the charging plug(s) (3) to the microphone(s) 3. The red Charging LED (4) shou
25 (1) Power switch. Turns the power on/off. (2) Power Indicator. Lights “amber” when the power is turned ON. (3) Infrared Microphone Volume Control [
26 Operating Controls EDS-07 IR SENSOR 1 3 4 2 5 Rear View Front View (1) Infrared sensor cover Protects sensor and allows IR light to enter. – Powe
27 Operating Controls AE-DCF Coupler (1) Infrared Sensor Connections [F-connector] Connect Infrared Sensors via F-connector and coaxial cable. (2)
28 Operating Procedure Example: Innovator Example: Student Microphone 1. Turn the power switch on the receiver to “ON”. (2) The power indicator
29 Using the Remote Volume Control The volume level of the infrared wireless microphones and the auxiliary inputs can be controlled from the teardr
3 Table of Contents Repair Form ……………………………………………. Power Cords for EU……………………………………. Safety Instructions for EU……………………………… WEEE Fitting…...………………………
30 Using the Microphone as a Transmitter (8) External input terminal on the side of the microphone. The infrared wireless microphone can be used as
31 Setting the Aux Mute (11) Input terminal (13) AUX mute setting switch ●Setting the Mute for the Audio Input of the Infrared Wireless Micr
32 Installation This connection diagram is an example of using 3 to 4 infrared wireless mi-crophones with the "Innovator" infrared receive
33 Installation Ultimate II DVD recorder etc. Specified AC adapter 3A-901DA24-048 ・・・ Pin plug ・・・ F-connector Coaxial cable 1/2: 1ch/2ch setting Bu
34 Installation Achiever DVD recorder etc. Specified AC adapter 3A-621DA24 ・・・ Pin plug ・・・ F-connector Coaxial cable 1/2: 1ch/2ch setting Bundle th
35 Installation RC-07 EDS-07 DVD recorder etc. Specified AC adapter 3A-621DA24 ・・・ Pin plug ・・・ F-connector Coaxial cable 1/2: 1ch/2ch setting Bundle
36 Installation Innovator EDS-07 Coaxial cable F-connector Coaxial cable Coaxial cable AE-DCF 1/2: 1ch/2ch 1/2: 1ch/2ch EDS-07 3/4: 3ch/4ch 3/4: 3c
37 Installation ●Precautions for Installing the Sensors ◎Install the infrared sensors in a position that allows them to receive the infrared signal r
38 Installation ●Precautions for Installing the Sensors ・Install the infrared sensor in a position from which the screen of the plasma display cannot
39 Installation Anchor strap Coaxial cable Adjuster Ceiling panel Installation bracket Installation screw ●Installing the Sensors: Part 1 Install th
4 Introduction AUDIO ENHANCEMENT has been creating technologically ad-vanced products that exceed expectations for over 25 years. They are designed b
40 Installation Installation Bracket: Diagram for bending Bend it according to the grooves. Anchor strap Coaxial cable Adjuster Ceiling panel In
41 Installation Receiving from1ch/2ch(3ch/4ch) ●Range and Expansion of the Sensor Reception ◎One dome type infrared sensor has a practical range of a
42 Installation Coaxial Cables INNOVATOR Coaxial cable :D AE-DCF EDS-07 Coaxial cable :A Coaxial cable :B Coaxial cable :E Infrared sensor connector C
43 Installation Coaxial Cables INNOVATOR Coaxial cable :D AE-DCF Coaxial cable : A Coaxial cable :B Coaxial cable: E Infrared sensor connector Coaxial
44 Setting the PA Aux Mute Caution : Wiring for the PA Input are fixed to the screw terminals. The torque for the screws is 0.98 N・m
45 Setting the PA Aux Mute (11) Auxiliary Inputs (15) PA input terminal (16) PA input volume PA cold signal PA hot signal ●Setting the Mute for th
46 Setting the EMG Aux Mute To activate the mute function, use a terminal jumper to connect the "+24 V BIAS“ terminal (17) and the "EMG CNT“
47 Setting the EMG Aux Mute Caution : Wiring for the ENG Input are fixed to the screw terminals. The torque for the screws is 0.98 N
48 About External Control Cable Innovator (18) Serial transmission terminal The Audio levels of the "Innovator“ can be remotely controlled by co
49 Precautions for Installation ● Precautions for Installing the Infrared Receiver and Infrared Receiver/Amplifier ◎Infrared Receiver and Infrared Re
5 Introduction When asked to rank the importance of nine different types of equipment used in classroom instruction, 34% of the teachers in general
50 Installing the Bracket Installing MTBR-07L(STC-98014) for the Ultimate II and Innovator Receiver Amplifier Please carefully read the following asse
51 Installing the Bracket Installing the UltimateII and Innovator Receiver Amplifier on MTBR-07L Install the Ultimate II and Innovator Receiver/Ampl
52 Installing the Bracket Installing MTBR-07S(BT77) Bracket for Infrared Receiver RC-07 and Achiever Receiver/Amplifier Please carefully read the fol
53 Installing the Bracket ● The Infrared Receiver RC-07 and Achiever Receiver/Amplifier on MTBR-07S Install the Infrared Receiver RC-07 and Infra
54 Fuse Part Numbers CAE-100W CAE-50W CAE-20W RC-07F101 021806.3MXP 0218004.MXP 021802.5MXP 0218.315MXPF401 0218002.MXP 0218002.MXP 0218002.MXPF402 02
55 TURN on the transmitter (green LED will indicate power, red LED indicates that batteries need to be recharged). POWER on the amplifier (red LED wi
56 Troubleshooting Transmitter is not working Is the battery light on your transmitter green? YES – Is the red light on your external sensor on?
57 Troubleshooting No Audio Is your power supply plugged into the amplifier/receiver and the wall out-let? YES – Is the power switch set to “On” an
58 Repair Form AUDIO ENHANCEMENT Ship Equipment to: Attn: Repairs 14241 S. Redwood Rd PO Box 2000 Bluffdale, UT 84065
59 Power Cords for EU Specified AC adapter PW-150A2-1Y-240E AC 220 - 240 V 50/60 Hz Innovator—CAE-100W Ultimate II—CAE-100W Specified AC adapter 3A-9
6 CE Declaration English We declare under our sole responsibility that the product to which this declara-tion relates is in conformity with the stand
60 Safety Instructions for EU Power disconnection. Unit with or without ON-OFF switches have power supplied to the unit whenever the power cord is ins
61 Safety Instructions for EU The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the lett
62 WEEE Fitting Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and
63 Audio Enhancement (“Provider”) is pleased to offer a standard Five (5) year lim-ited manufacturers warranty (“Limited Warranty”) against malfunct
7 CE Declaration Swedish Vi deklarerar härmed värt fulla ansvar för att den produkt till vilken denna deklaration hänvisar är i överensstämmelse med
8 Safety Instructions WARNING: • To reduce the risk of fire or electric shock, do not expose this re-ceiver/amplifier to rain or moisture. • The a
9 Safety Instructions WARNING: • This apparatus must be earthed. • Apparatus shall be connected to a main socket outlet with a protective earthing
Kommentare zu diesen Handbüchern